08
Toilet installation
Precaution before installing
Minimum dynamic working water
pressure: 0.18+ MPa (5.81+ gal/min or 22+
L/min), failure to meet this pressure will
not achieve the best flushing effect.
Note: Apply the methods below if you
don’t have water pressure testing device.
Open the angle valve to check the water
volume. If the water volume after 10
seconds is greater than 0.97Gal (3.7L), then
it is OK to proceed installation.
Angle valve
Hose
Water storage
barrel
Note: It is recommended to use a
high quality 6LR61 9V battery.
1.. Installation of backup battery box
The backup battery box allows you to
flush the toilet in the event that your
home loses power.
Insert a 9V battery into the box and plug
the connector into the wire harness
under the toilet.
Place battery box at the bottom of
toilet.
battery
12”
Drain outlet
3.. Cardboard template
Align cardboard with the centerline
of drain outlet
Use template as a guide for
positioning
1/2” NPT compression inlet
If the existing angle shut-off valve at the
wall is at least 8” off the center of the
drain and uses either a 3/8”
compression or 1/2” NPT thread, then it
can be used.
If not, the supplied angle valve can be
installed.
Installing the supplied 1/2” angle valve
and larger hose will provide optimal
flushing performance.
Draw drain outlet centerline on the floor,
install angle valve at least 8” away at an
appropriate height to clear the toilet
skirt.
2.. Installation of angle valve (optional)
Line
Drain outlet
Angle valve
Summary of Contents for UX-T Pearl
Page 1: ...UXT Pearl...
Page 20: ......
