7
Completed Roof Support
16. Attach ROOF SUPPORT over walls
Position the completed Roof Support over the wall
sections. Once in place on all 4 sides, use 2”
screws to attach Roof Support to wall sections.
Use 4 evenly spaced screws per rail.
NOTE:
Tap the Roof Support firmly in place
with a rubber mallet so wall sections are fully in-
serted into the groove before screwing into place.
Attach Roof Support over walls
17. Position ROOF SECTIONS
Place two Roof Sections on top of Roof Support,
nesting the tongue of one section into the groove
of the other. Measure around perimeter before fas-
tening to be sure distance from edge is equal.
NOTE:
Finished side of Roof Sections are to face
the interior of the sauna with battens facing up.
Position Roof Sections
18. Fasten ROOF SECTIONS
Using 2” screws, fasten Roof Sections to Roof
Support using pre
-
drilled holes.
NOTE:
Be sure to keep even distance from edge
of Roof Section edges and Roof Support edges
around perimeter of sauna as measured in step 17.
Fasten Roof Sections to Roof Support
15. Build ROOF SUPPORT
Assemble 4 roof support rails by angle
-
screwing
with 2” screws through the pre
-
drilled holes.
NOTE:
Be sure that the rails are square and level
and that the screw head does not protrude into the
groove.
