AlluGuard AG55, Operating, Maintenance, Servicing And Installation Manual

Page: 21 / 28

20 21
Programming the XSE Transmitter in to the Rollixo Receiver
Press the ‘Prog’ button on the Rollixo RTS front panel until the LED above the Prog button lights up RED.
Press the ‘PROG’ button on the safety edge transmitter for approximately 4 seconds until the ‘Prog’ LED on
the Rollixo RTS controller flashes and then goes out.
The safety edge transmitter is now paired, check the operation of the door & check the safety edge
activates when compressed.
Please refer to the Somfy instructions on commissioning a safe edge if required.
10. Position the Magnets on the Door Guide
& Programming the Safety Edge Transmitter
Start with the roller door at its top limit, if positioning the top magnet (AG55 Doors with 12RPM Motor) you
should measure down 50mm from the bottom of the safety edge transmitter and turn on dipswitch 4 within
the safety edge transmitter. The top magnet housing should be placed flush with the edge of the guide, as
shown in
Fig 23.
Fix the top magnet to the guide using the adhesive pad provided until the roller door is commissioned and
then fix using the self tapping screws provided.
To position the bottom magnet, close the roller door to the fully closed position. Mark the guide rail to match
the arrow indicted on the XSE transmitter; now raise the door up so the transmitter is in the middle of the
opening. Now fit the magnet where the guide rail was previously marked using the adhesive pad provided,
now send the door down and check that the XSE transmitter turns off when aligned with the magnet, the
green LED on the XSE transmitter should go out! Once the safety edge transmitter is in full working order then
fix using the self tapping screws provided. As shown in
Fig 24.
Fig 23
Fig 25
Fig 24