ALLPOWER EPW2000, Owner'S Manual

Page: 9 / 24

ALL POWER™ EPW2000 POWER WASHER | 9
OPERATING INSTRUCTIONS
NOTE: THIS UNIT IS INTENDED FOR
USE WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS
PRESSURE WASHER.
Bleeding The Gun
It is very important to bleed all the air out of
the pressure washer before using it. To do this:
1. Release trigger lock.
2. Squeeze the trigger before turning the
electrical supply on. This removes any air
trapped inside the pressure washer and
lance before using the units.
3. Continue holding trigger for approximately
one minute to allow any excess air out of the
unit. Water will flow through the gun at low
pressure during this procedure.
4. Lock the trigger.
5. Plug the mains power cable into the
electricity supply.
6. Release the trigger lock.
7. Turn the ON/OFF switch clockwise to the
I/ON position. The pressure washer is ready
to using now.
Starting Up
After connecting the pressure washer to your
cold water supply, proceed as follows:
- Make sure that the ON/OFF switch is
in the OFF position.
- Connect the garden hose with quick
connect to the inlet fitting.
- Attach the hose to the gun.
- Insert the adjustable spray nozzle
into the gun.
- Connect the high pressure hose to
the high pressure outlet fitting.
- Open the water supply valve completely.
- Before turning the unit on, press the gun
trigger to bleed all the remaining air out
of the pump and hose.
- Start the pressure washer by turning the
on/off switch to the on position and
squeeze the trigger.
REMINDER: Motor does not run continuously,
only when the trigger is squeezed.
WARNING
RISK OF INJECTION! Unit will start spraying
when trigger is squeezed. When turning the unit
off after use, high pressure still exists inside the
hose and unit. Point the gun in a safe direction
and discharge the excess pressure. NEVER direct
the high pressure water stream at people or
animals.
Automatic On / Off
The pressure washer is equipped with an
automatic ON/OFF switch. The pressure
washer will only run when the power switch is
in the ON position and the trigger on the gun
is squeezed. When you release the trigger to
stop spraying water through the gun, the
motor on the pressure washer will
automatically shut off. Simply squeeze the
trigger again to resume using the washer. To
stop using the pressure washer, release the
trigger and switch the unit to the OFF position.
The unit should be turned completely
OFF while not in use or while unattended.
OWNER’S MANUAL | OPERATION 9