16
Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and
powered on, you can configure the ALL6800 so that it is accessible to your
network users. There are two ways to set up your ALL6800: using the ALLNET
Setup Wizard or the LCD display. Follow the steps below for initial software
setup.
ALLNET Setup Wizard
The handy ALLNET Setup Wizard makes configuring ALL6800 a snap. To configure
the ALL6800 using the Setup Wizard, perform the following steps:
1.
Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2.
The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
3.
The Setup Wizard will start and automatically detect all ALLNET storage
devices on your network. If none are found, please check your connection
and refer to
Chapter 8: Troubleshooting
for assistance.
4.
Select the ALL6800 that you like to configure.
NOTE
For MAC OS X users, double click on ALLNET Setup Wizard 1.1.99.dmg