14
Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and powered
on, you can configure the ALLNET IP storage so that it is accessible to your network
users. There are two ways to set up your ALLNET IP storage: using the ALLNET
Setup Wizard or the LCD display. Follow the steps below for initial software
setup.
ALLNET Setup Wizard
The handy ALLNET Setup Wizard makes configuring ALLNET IP storage a snap. To
configure the ALLNET IP storage using the Setup Wizard, perform the following
steps:
1.
Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2.
The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
3.
The Setup Wizard will start and automatically detect all ALLNET storage
devices on your network. If none are found, please check your connection
and refer to
Chapter 6: Troubleshooting
for assistance.
NOTE
For MAC OS X users, double click on ALLNET Setup Wizard .dmg file.
