Allied Skid-Pac 1000, Safety, Operation, Maintenance And Parts, Page: 23 / 44

Allied Construction Products, LLC www.alliedcp.com
TM103349_SP1000B_15sep 13
9.0 Care and Maintenance - [cont’d]
WARNING
Crush injury. Any guard removed
from the equipment for purpose of
inspection or maintenance must be
reinstalled before returning back to
work.
WARNING
Injury from pressurized fluid. Fluid under
pressure can penetrate skin. Never use
hands to locate leaks. Use cardboard.
Regularly inspect hoses for damage. Replacement
hoses must be the same type and pressure rating.
CAUTION
Personal protection equipment,
including safety eyewear, must be worn
when operating or servicing this
equipment.
CAUTION
Hot surface - Burn injury if contacted.
Some components of the machinery
become hot during operation. Allow parts
and fluids to cool before handling.
IMPORTANT
Do not make alterations to the Skid-Pac without
written authorization from the Allied Engineering
Department.
9.3 10 Hour (Daily) Maintenance

Remove any excessive dirt/debris on the Skid-
Pac as this can decrease performance.

Check for loose or missing fasteners.

Check components for excessive wear.

Check spring mounts for cracks.

Check fasteners for tightness. Check and replace
any threaded fasteners that are missing or
damaged. Follow proper torque procedures.

Check hoses and connections for oil leaks.
Replace damaged or deteriorated hoses. Replace if
any of the following conditions are present:

Leak at end fitting that cannot be eliminated
through proper tightening techniques

Outer coverings are chafed or cut.

Wires are exposed

Outer coverings are ballooning

Flexible part of the hoses are kinked

Outer covers have embedded armoring

End fittings are displaced
9.4 Check Carrier’s Oil Level and Quality
CAUTION
Follow the recommended service
intervals from the carrier manufacturer.
Check oil level in reservoir. Check records for last oil
and filter service. Test oil quality. Review the
manufacturer's maintenance schedule. It may specify
operating conditions that require special attention to
maintenance and adjusted service intervals.
Maintain clean oil in the carrier. Follow the
recommendations from the carrier manufacturer for
approved hydraulic oils and hydraulic system
maintenance.
IMPORTANT
Contamination will diminish service life of
components. Use care while performing service to
hydraulic systems. Safeguard against contaminating
the oil. Before connections are opened, ensure fluids
are collected in a suitable container. Clean up any
spilled oil. Obey all local regulations for the disposal
of these fluids.
9.5 Bearing Lubrication System – 1000B
Bearings are lubricated for life and sealed. No regular
re-lubrication is necessary nor possible.
9.5.1 Bearing Lubrication System – 1000
The bearings are continuously lubricated during
operation from the oil splash system located within
the eccentric housing. The sealed system contains
the oil and protects it from outside contamination.
9.5.2 Bearing Lubrication Type & Capacity (1000)
The oil level must be checked regularly and
maintained at a specific height to allow adequate oil
splash.
Check daily for visible oil leaks.

If leaks are detected, check oil level

Determine cause of leak, (e.g. loose bolts, faulty
gasket) and make necessary repair.