Allied Telesis XS910/8, Manual

Page: 49 / 62

Chapter 4: Installation Using the AT-RKMT-J14 Rack Mount Kit
49
Installing a Switch Using the AT-RKMT-J14 Rack Mount Kit
This section shows you steps to install a switch in an equipment rack using
the AT-RKMT-J14 kit.
What to Prepare
Before installing a switch to an equipment rack, make sure that the
following items are ready.

Two AT-RKMT-J14 rack mount brackets

Two AT-RKMT-J14 handles

Four M3x6mm screws (Included in the AT-RKMT-J14 kit)

Eight M4x6mm screws (Included in the AT-RKMT-J14 kit)

Four screws for the equipment rack

Phillips-head screw driver
Installing a
Switch Using the
Rack Mount Kit
To install a switch in a rack using the AT-RKMT-J14 rack mount kit,
perform the following procedure:
1. Review “Reviewing Safety Precautions” on page 26 and “Selecting a
Site and Planning the Installation” on page 29 before performing this
procedure.
2. Place all the items from the packaging on a work table.
3. Attach the handles to the brackets as shown in Figure 19.
Figure 19. Attaching the Handles to the Brackets