Allied Telesis TQ5403, Installation Manual, Page: 29 / 82

TQ5403 and TQm5403 Wireless Access Points Installation Guide
29
network device that does not support automatic MDIX detection.
Cable
Requirements
The minimum cable requirements for the ports are listed here.

10 Mbps or 100 Mbps: Standard TIA/EIA 568-B-compliant Category 3
shielded or unshielded cabling.
 1000 Mbps: Standard TIA/EIA 568-A-compliant Category 5 or TIA/EIA
568-B-compliant Enhanced Category 5 (Cat 5e) shielded or
unshielded cabling.
Maximum
Distance
The LAN ports have a maximum operating distance of 100 meters (328
feet).
Port Pinouts
Refer to Table 9 on page 61 for the port pinouts of the LAN port when it is
operating at 10/100 Mbps in the MDI configuration and Table 10 on
page 62 for the MDI-X configuration. Refer to Table 11 on page 62 for the
port pinouts when the port is operating at 1000 Mbps.
Guidelines
Here are the guidelines to using the LAN1 and LAN2 ports:
 If you are connecting only one LAN port to your network, you must
use port LAN1.
 To use both ports, you have to connect them to the same network
device, such as an Ethernet switch or router, or virtual stacking
devices. Do not connect the LAN ports to different network
devices.
 The network device has to support static LAGs.
 The default setting for the LAN2 port and static LAG on the
wireless access point is disabled. You enable them with the
on-board web browser management interface.
Caution
Do not activate the LAN2 port until you have configured the ports on
the network device to which the LAN ports are connected as a static
LAG. Refer to the documentation for the network device for
instructions.