Allied Telesis TQ5403, Installation Manual, Page: 53 / 82

TQ5403 and TQm5403 Wireless Access Points Installation Guide
53
Attaching the Access Point to the Mounting Bracket
To attach the wireless access point on the mounting bracket on the wall or
ceiling, perform the following procedure:
1. Align the bottom of the access point over the bracket so that the two
screws on the bottom of the device fit into the bracket keyholes. Refer
to Figure 21. (These are the two access point chassis screws installed
in “Pre-fitting the Mounting Bracket on the Access Point” on page 43.)
Figure 21. Installing the Access Point on the Mounting Bracket
2. Slide the access point forward until its screws are seated in the bracket
keyhole slots and the bracket thumbscrew is aligned with the screw
hole on the front panel. Refer to Figure 22 on page 54.