Allied Telesis MIB Structure (SIP/MGCP/NCS), Reference Manual

Page: 47 / 80

VP500 Communication Unit 37
12
apaCmdGroup Parameters
The APA Command Group parameters are used to initiate tasks on the
VP500 communication unit.
apaCmdGroup
Parameters
The following tasks can be initiated.
Table 44: APA Cmd Group Parameters
Name Access Description Dynamic
apaCmdStartTelnetBenchTest R/W Instruct the VP500 communication unit to reboot in Telnet bench
test mode.
0 = Off
1 = On
Default Value : 0
Yes
apaCmdMode R/W Not implemented ... for future use only.
Select the VP500 communication unit command mode.
0 = Enable the VP500 communication unit
1 = Disable the VP500 communication unit
2 = ReEnable the VP500 communication unit
3 = Abrupt Restart (software reset immediately)
4 = Graceful Restart (software reset when all calls have
terminated)
5 = Abrupt Shutdown (harware reset immediately)
6 = Graceful Shutdown (harware reset when all calls have
terminated)
7 = Reset all statistics
8 = Other
Default Value :
Yes
apaCmdConfigurationMode R/W Select the VP500 communication unit configuration mode.
• -1 = Request and wait for the Config File. When the
mode is set to -1, a Config File Trap Info is sent to
the apaManager to request a config file upload.
The value is set back to 0 after the file is received.
NOTE: The mode must be set to 1 to apply any
new setting.
• 0 = Record any changes (TFTP or SNMP) -
Changes are recorded but won't be applied until
the mode is set back to Commit.
• 1 = Commit all changes - In this mode changes are
automatically applied. NOTE: Some changes may
require to reboot the system to take effect.
• 2 = Undo all recorded changes - All changes
recorded will be dismissed. The mode is set back
to 1 afterward.
Default Value : -1
Yes
apaCmdCheckRom R/W Check the validity of the ROM.
0 = Off
1 = On
Default Value : 0
Yes