Chapter 7 - portGroup Parameters
MIB Reference Manual - Provisioning MIB
VP500 Communication Unit
24
portnDspGroup
The following parameters allow you to set DSP parameters.
portnDspUser-
GainGroup
portSilenceDetectionTimeout
R/W
When silence is detected on the line, period of silent time after
which the line is hanged up. 300 seconds = 5 minutes. Values
range from 0 to 300 seconds.
Default Value
: 300
No
portForcedEndOfCallEnable
R/W
Enable call interruption if unsuccessfull.
0 =
Disable
1 =
Enable
Default Value
: 1
No
portForcedEndOfCallTimeout
R/W
Forced end of call timeout in seconds. Values range from 0 to 180
seconds.
Default Value
: 30
No
Table 24:
Port Parameters (Continued)
Name
Access
Description
Dynamic
Table 25:
DSP Parameters
Name
Access
Description
Dynamic
portnDspMaxJitterBufferLen
R/W
Port #n maximum jitter buffer length in ms.
Default Value
: 150
No
portnDspTargetJitterBufferLen
R/W
Port #n target jitter buffer length in ms.
Default Value
: 50
No
portnDspAdaptativityJitterBuffer
R/W
Port #n adaptative jitter buffer.
0 =
OFF
1 =
ON
Default Value
: 1
No
portnDspVoiceActivityDetection
R/W
Port #n Voice Activity Detection (VAD).
0 =
OFF
1 =
Transparent
2 =
Conservative
Default Value
: 2
No
portnDspEchoCancelControl R/W
Port #n echo cancel control.
0 =
OFF
1 =
ON
Default Value
: 1
No
Table 26:
DSP User Gain Parameters
Name
Access
Description
Dynamic
portnDspUserGainInputOffset
R/W
Port #n user input gain offset in dB.
Default Value
: -6
No
Summary of Contents for MIB Structure (SIP/MGCP/NCS)
