Allied Telesis FastPrint Server, User Manual, Page: 47 / 100

Chapter 6. TCP/IP Features
FTP
FastPrint Server User’s Guide
37
♦
dir
List files (as shown in the previous table).
♦
get FILENAME
Retrieve a file. The only files that can be retrieved are CONFIG and PSINF.
Using GET with the other “files” will activate a command, as follows:
get DEFAULTC Set the FastPrint back to its default configuration.
get RESET Reset the FastPrint Server. This also terminates the
current connection.
get PASSRESET Clear password (no password).
get SETIP Set the current IP address as a static IP address.
Warning!
Do not use the SETIP command if the FastPrint has an IP address
assigned by a DHCP server. This will cause an Address conflict.
♦
put CONFIG
Copy the file CONFIG to the FastPrint, overwriting the existing CONFIG file.
Details of the format of CONFIG files are contained in
Appendix B -
Configuration File Format .
Note:
After using the put CONFIG command to write a new configuration file to
the FastPrint, you should issue a get RESET command.
The red LED should then go on while the FastPrint Server is resetting.
When the red LED goes OFF and the green LED starts flashing, the
FastPrint is ready. A RESET will terminate the current connection.
♦
put PASSWORD
Copy the file PASSWORD to the FastPrint Server, giving it a new password.
Passwords can be up to 19 bytes in length.
♦
put filename Ln
Copy the file filename to the printer connected to logical port n , where n is a
logical port number. This will print the file.
♦ quit
Terminate the current FTP session.
♦
Other FTP commands
The other FTP commands are not implemented, and will usually return the error
message
Invalid command .
6.1.1.3. Example: Initial configuration
1. Connect to the FastPrint Server.
ftp NAME
Note:
You can only connect using a name instead of an IP address if your system
has been configured as described on page 24.
2. You will be prompted for User . Enter the default name (on the base of the FastPrint).
When prompted for the password, press E
NTER
.