Allied Telesis AT-IMC2000T/SC, Installation Manual

Page: 14 / 58

IMC2000/200 Series Media Converter Installation Guide
14
DIP Switches
The media converter is equipped with the DIP switches. Figure 2 shows
the DIP switches on the media converter.
Figure 2. DIP Switches
To configure the media converter, use the following DIP switches:

SML - Turn on or off the SML feature.

FORCE 100FD - Select Auto Negotiation or set the port speed for
100Mbps in full-duplex mode.

REMOTE PoE CONTROL - Activate or deactivate remote PoE which
allows you to remotely power cycle your PoE device.
Note
The only AT-IMC2000TP/SP, AT-IMC2000TP/SC, and
AT-IMC200TP/SC models are equipped with the Remote PoE
Control DIP switch. DIP switch 3 is not used for the other models.
DC Power
The IMC2000/200 series media converter is equipped with the DC power
connector.
Twisted-Pair Port
The twisted-pair port features an eight-pin RJ45 connector that uses four
pins at 10 or 100 Mbps and all eight pins at 1000 Mbps. For the port
pinouts, see “RJ45 Connector and Port Pinouts” on page 50.
The port has a maximum operating distance of 100 m (328 feet). For
twisted-pair port cabling specifications, refer to Table 3 on page 27.
Auto-Negotiation
or 100 Mbps
Setting
You can set the twisted-pair port to 100 Mbps full-duplex mode or Auto-
Negotiation mode using the DIP switch See Figure 2 on page 14.

When this DIP switch is in the FORCE 100 F/D (up) position, the
twisted-pair port is forced to 100 Mbps full-duplex mode, and Auto
Negotiation is disabled

When in the AUTO NEG (down) position, the twisted-pair port
operates in Auto-Negotiation mode.