Allied Telesis AT-8000S Series, Cli Reference Manual

Page: 148 / 304

Page 146
Allied Telesyn AT-8000S Switch
CLI Reference Guide
Chapter 17.Radius Commands
radius-server host
The radius-server host Global Configuration mode command specifies a RADIUS server host. To delete the
specified RADIUS host, use the no form of this command.
Syntax
radius-server host { ip-address | hostname } [ auth-port auth-port-number ] [ timeout timeout ] [ retransmit retries ]
[ deadtime deadtime ] [ key key-string ] [ source source ] [ priority priority ] [ usage type ]
no radius-server host { ip-address | hostname }
Parameters
•
ip-address — IP address of the RADIUS server host.
•
hostname — Hostname of the RADIUS server host. (Range: 1-158 characters)
•
auth-port-number — Port number for authentication requests. The host is not used for authentication if the
port number is set to 0. (Range: 0-65535)
•
timeout — Specifies the timeout value in seconds. (Range: 1-30)
•
retries — Specifies the retransmit value. (Range: 1-10)
•
deadtime — Length of time in minutes during which a RADIUS server is skipped over by transaction
requests. (Range: 0-2000)
•
key-string — Specifies the authentication and encryption key for all RADIUS communications between the
device and the RADIUS server. This key must match the encryption used on the RADIUS daemon. To specify
an empty string, enter "". (Range: 0-128 characters)
•
source — Specifies the source IP address to use for communication. 0.0.0.0 is interpreted as request to use
the IP address of the outgoing IP interface.
•
priority — Determines the order in which servers are used, where 0 has the highest priority. (Range: 0-65535)
•
type — Specifies the usage type of the server. Possible values: login , dot.1x or all .
Default Configuration
No RADIUS server host is specified.
The port number for authentication requests is 1812.
The usage type is all .
Command Mode
Global Configuration mode
User Guidelines
To specify multiple hosts, multiple radius-server host commands can be used.
If no host-specific timeout, retries, deadtime or key-string values are specified, global values apply to each
RADIUS server host.
The address type of the source parameter must be the same as the ip-address parameter.