14
39201
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
8. CONSTANT AGITATION
9. WASHER OVERHEATS, CYCLES ON MOTOR THERMAL PROTECTOR, SWITCH ACTUATOR
KICKS IN AND OUT
POSSIBLE CAUSE
TO CORRECT
Inoperative timer.
Test timer and replace if inoperative.
Shorted or incorrect wiring.
Refer to appropriate wiring diagram.
Inoperative transmission assembly.
Repair or replace transmission assembly.
POSSIBLE CAUSE
TO CORRECT
Belt is tacky and does not allow proper slip.
Check belt and replace if defective.
Belt tension is too great and does not allow proper
slip.
Make sure idler spring is properly connected.
Inoperative timer.
Test timer and replace if inoperative.
Motor switch functions inoperative.
Refer to Section 7 to check switch functions.
Bind in water pump.
Replace pump.
Brake pads or brake assembly binding.
Free binding pads, or replace pads and brake assembly.
Bearings, transmission or motor has locked up and
will not turn.
Check that all these components are able to move freely.
Correct binding component.
Incorrect voltage.
Contact local utility company, or have a qualified electrician
check power supply.
