12
39201
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
4. WATER FILL DOES NOT STOP AT PROPER LEVEL
5. TIMER DOES NOT ADVANCE
POSSIBLE CAUSE
TO CORRECT
Inoperative pressure switch.
• Test switch and replace if inoperative.
Air leak in pressure hose.
• Replace hose.
Sediment on or under mixing valve diaphragm,
defective diaphragm, or armature binding in
armature guide.
• Disassemble and clean mixing valve.
Broken, weak or missing mixing valve armature
spring.
• Disassemble valve and replace spring.
A siphoning action started in washer will cause
water to be siphoned from washer during cycle due
to end of drain hose being lower than cabinet top of
washer. Drain hose fits tight in standpipe or drain.
• Install No. 562P3 Siphon Break Kit. Provide an air gap
around drain hose and drain receptacle.
Water in pressure hose.
• Blow air through hose to remove water.
Broken, loose, shorted or incorrect wiring.
• Refer to appropriate wiring diagram.
POSSIBLE CAUSE
TO CORRECT
Timer is designed to pause during fill periods.
• Allow completion of fill period.
Inoperative timer.
• Test timer, and replace if inoperative.
Loading door is open.
• Close loading door. Loading door MUST be closed any
time the washer is set to fill, agitate or spin.
Washer will not fill.
• Timer pauses until pressure switch is satisfied.
Timer motor lead wire off timer terminal.
• Refer to appropriate wiring diagram and reattach wire.
Broken, loose or incorrect wiring.
• Refer to appropriate wiring diagram.
Timer is designed to pause when going from agitate
to spin.
• Allow time for timer to go through that step. See diagram
for information on time required.
Timer is designed to stop if washer drive motor has
been over loaded and motor thermal overload has
tripped.
• Motor thermal protector reset time may vary depending
upon the reason for the washer overload, however, it
should reset within 15 minutes. Check to ensure that
washer was not overloaded with clothes.
Is circuit breaker to washer tripped, disconnecting
power to washer.
• Reset circuit breaker.
Washer will not fill.
• Timer is designed to pause when going from spin into
rinse to allow the washtub to stop spinning before filling,
make sure that timer has advanced into fill portion of rinse
cycle.
