© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
1300003 (EN)
40
Replacement of Return Ribbons
To replace return ribbons, perform the following steps.
1. Remove both side panels from the finisher.
2. Locate the return ribbon tension systems on each
side of the finisher. Refer to
Figure 33
.
3. Remove tension screw and bracket from tension
spring on each side of finisher.
4. Unhook the return ribbon tension spring from the
tension pin on each side of finisher. Refer to
Figure 34
.
5. Remove rear panel from finisher.
6. Use manual crank to move cylinder until return
ribbon connection point is at top of rear drive
roller.
7. Remove pin from teeth of return ribbon. Refer to
Figure 35
.
NOTE: Do not release bottom portion of return
ribbon.
FWF28N
1
Tension Screw
2
Bracket
Figure 33
RIGHT SIDE OF FINISHER
1
2
1
2
FWF5N
1
Tension Spring
2
Tension Pin
Figure 34
FWF30N
1
Guide Ribbons
2
Flap of Return Ribbon
3
Pin
4
Return Ribbon Guide
Figure 35
1
2
1
2
3
4