© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Safety Information
1300003 (EN)
8
Safety Notice
CAUTION: Note for installation.
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the NATIONAL
ELECTRICAL CODE, ANSI/NFPA 70, or Canadian
Electrical Code, CSA C22.1.
The installation must comply with local codes or, in
the absence of local codes, with the current National
Fuel Gas Code, ANSI Z22.1, or the current CAN/CSA
B149, Installation Codes.
The appliance and its appliance main gas valve must
be disconnected from the gas supply piping system
during any pressure testing of that system at test
pressures in excess of 1/2 psi (3.5 kPa).
The appliance must be isolated from the gas supply
piping system by closing the equipment shutoff valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2 psi
(3.5 kPa).
The installation must include a 1/8 NPT pressure tap
accessible for test gage connection immediately
upstream of the gas supply connection to the finisher.
There must be provisions for adequate combustion and
ventilation air, clearance around air openings intake
combustion chamber and accessibility clearances for
servicing and operation.
Important Safety Instructions
Save These Instructions
1. Read all instructions before using the finisher.
2. Refer to the
Grounding Instructions
for the
proper grounding of the finisher.
3. Do not iron articles that have been previously
cleaned in, washed in, soaked in, or spotted with
gasoline, dry cleaning solvents, or other
flammable or explosive substances as they give
off vapors that could ignite or explode.
4. Do not allow children to play on or around the
finisher. Close supervision of children is
necessary when the finisher is used near children.
This is a safety rule for all appliances.
5. Check the operation of the safety finger guard at
the beginning of every shift. Operating the safety
guard should stop the finisher immediately. If this
safety feature is not working properly, employees
must shut off the finisher and notify the
supervisor. Do not operate the finisher until the
safety finger guard is repaired and working
properly. Be sure that all other safety features,
including guards and panels, are in place before
operating the finisher.
• Failure to install, maintain, and/or operate this machine according to the manufacturer’s
instructions may result in conditions which can produce serious injury, death, and/or
property damage.
• Do not repair or replace any part of the machine or attempt any servicing unless specifically
recommended or published in this Installation/Operation Manual and that you are qualified
to carry out.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded and to reduce the risk of fire,
electric shock, serious injury, or death.
W566
•
WARNING
WARNING
To reduce the risk of fire, electric shock,
serious injury or death to persons when
using your flatwork finisher, read and
follow these basic precautions:
W541