Alliance Laundry Systems HTEB17-N2802, Service Manual

Page: 142 / 180

140
801774
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
94. LIMIT THERMOSTAT
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 39 .
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to Figure 47 .
c. Disconnect wires and remove screws holding
limit thermostat to burner housing (gas models)
or element plate (electric models). Refer to
Figure 51 .
95. HEATER ASSEMBLY (Electric Models)
a. While supporting access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 39 .
b. Gently lower access panel to disengage locators
from bottom edge of front panel. Refer to
Figure 47 .
c. Remove two screws holding heater assembly to
heater box and remove heater assembly out
through front of dryer. Refer to Figure 51 .
d. Disconnect wires from heater assembly. Refer
to Figure 51 .
NOTE: When reassembling, be sure all wire
connectors are tight on element terminals, thermal
fuse and limit thermostat.
96. THERMISTOR
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 39 .
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to Figure 47 .
c. Disconnect wires and remove thermistor
attaching screws. Refer to Figure 51 .
Figure 52
Attachin g
Screw s
Seal
Thermi s tor
Wire
Harne ss
D324 S E3C