Alliance Laundry Systems HTEB17-N2802, Service Manual

Page: 130 / 180

128
801774
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
b. Apply a film of grease to area of shaft that will
be contacting the bearing housing seal. Refer to
Figure 37 . Make sure seal lips also are packed
with grease. Refer to Figure 37 .
IMPORTANT: When installing inner basket, the
following steps must be taken to ensure that the seal
is properly orientated:
c. Install inner basket assembly by pushing all the
way into outer tub.
d. Install pulley, flat washer, lockwasher and left
hand thread screw. Refer to Figure 36 .
IMPORTANT: When installing pulley, always use
a new cap screw (included in kit) to prevent screw
from loosening during operation. Use a thread tap
to clean old Loctite out of pulley screw receiving
hole before installing new screw. This ensures that
inner basket and pulley properly seat.
e. Unscrew left hand thread screw half way.
f. Install pulley bolt tightening fixture between
the flat washer and the pulley. Refer to
Figure 38 .
g. Tighten left hand thread screw until washer is
against pulley bolt tightening fixture.
h. Loosen screw about one half turn to free
fixture.
i. Remove pulley bolt tightening fixture.
j. From front of washer, pull inner basket forward
as far as possible. Flat washer should be against
pulley.
k. Push inner basket back into outer tub as far as
possible.
l. Tighten left hand thread screw. Be careful not
to push the trunnion shaft forward while
tightening the screw.
NOTE: Torque new left hand thread screw to 240
minimum to 260 maximum inch pounds (27.5 to
29.7 Nm).
80. DRYER ACCESS PANEL
Refer to Figure 39 .
a. While supporting access panel, remove two
screws from bottom edge of panel.
b. Gently lower access panel to disengage panel
locators from bottom edge of front panel.
c. Remove access panel.
Figure 39
Acce ss
Panel
Panel
Attachin g
Screw s
D302 S E3B