Alliance Laundry Systems HTEB17-N2802, Service Manual

Page: 166 / 180

164
801774
Section 6 Adjustments
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
i. Check coin return pendulum to verify it swings
freely. If pendulum does not swing freely, spray
pendulum pivot point with Teflon based
lubricant and move pendulum back and forth
two to three times. An additional application of
Teflon based lubricant may be necessary to
ensure that pendulum swings freely. Refer to
Figure 79 .
j. Check coin drop sensor for dust or dirt on eyes.
Wipe eyes with dry cotton swab. Refer to
Figure 80 .
IMPORTANT: DO NOT use isopropyl alcohol to
clean electronic sensor or eyes.
k. Reinstall coin return on to coin drop frame.
l. Reinstall metal clip and slide towards coin
insert slot. All cotter pin holes must line up.
m. Reinstall cotter pin.
n. Place drop on level surface to verify that coins
follow correct path in drop. It may be necessary
to lift drop to allow coin to follow through
sensor.
o. Reinstall coin drop into machine. Refer to
Paragraph 57 .
p. Reconnect electrical power to machine and
drop.
q. Add a coin to drop to verify that coin drop is
operating properly and that electrical
connection is working properly.
NOTE: If coin drop does not operate properly after
above steps have been completed, corrosion of metal
or vandalized components within coin drop may be
preventing the coin drop from functioning
correctly. Replace coin drop.
Figure 79
DRY6B
Pivot
Point
Pendulum
Figure 80
DRY7B
Eyes
Dry
Cotton
Swab