Alliance Laundry Systems HTEB17-N2802, Service Manual

Page: 132 / 180

130
801774
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
81. CABINET TOP
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 39 .
b. Gently lower access panel to disengage panel
locators from bottom edge of access panel.
Refer to Figure 39 .
c. Remove two screws holding bottom tabs on
front panel to dryer cabinet. Refer to Figure 40 .
d. Swing bottom of front panel away from dryer to
disengage hold-down clips and locators from
cabinet top.
e. Disconnect wires from door switch. Refer to
Figure 46 .
NOTE: Refer to wiring diagram when rewiring
switch.
f. Remove two screws holding cabinet top to front
flange of cabinet. Refer to Figure 41 .
g. Lift cabinet top to a vertical position by hinging
it on the rear hold-down brackets. Refer to
Figure 42 .
NOTE: While servicing, cabinet top may be raised
and hinged on the rear hold-down brackets or
supported against wall behind dryer.
Figure 40
DRY977 S
505617
Front Panel
Attaching
Screws
Figure 41
Figure 42
D394 S
Cabinet Top
Hold-down Screws
Cabinet
Top
D352 S E1A
Rear
Hold-Down
Bracket s