Alliance Laundry Systems EE1010, Service Manual

Page: 39 / 89

40
505872
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
n. Lift cabinet top to a vertical position by hinging
it on the rear hold-down brackets. Refer to
Figure 15.
NOTE: Cabinet top may be raised and hinged on
the rear hold-down brackets or supported against
wall behind dryer while servicing.
o. Carefully withdraw the wire harness through
hole in cabinet top and lift the top off the hold-
down brackets with meter case attached. Refer
to Figure 15.
p. Lay cabinet top flat, remove two carriage bolts,
washers, lockwashers and nuts holding meter
case to cabinet top and remove the meter case.
Refer to Figure 12.
q. Remove brace from underside of cabinet top by
swinging one end toward front or rear. Refer to
Figure 15.
34. CABINET TOP – CARD READER MODELS
a. Remove panel lock (if present). Refer to
Figure 7.
NOTE: Several turns of the key may be required to
remove panel lock.
b. Remove two control panel attaching screws and
lift assembly off cabinet top. Refer to Figure 7.
c. Disconnect the wires from the timer and relays.
Refer to Figure 7.
d. Remove the screws and grounding clip holding
the green ground wire to the cabinet top, control
panel and timer. Refer to Figure 6.
e. Remove two screws holding timer mounting
bracket assembly to cabinet top and lift
assembly off cabinet top. Refer to Figure 7.
f. Remove two screws holding control hood to
cabinet top, lift hood off rear tabs and set to the
side with the reader control wires still attached.
Refer to Figure 7.
g. Remove two screws from bottom edge of front
panel. Refer to Figure 13.
h. Swing bottom of panel away from dryer to
disengage hold-down clips and guide lugs from
cabinet top. Refer to Figure 13.
i. Disconnect wires from door switch. Refer to
Figure 18.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
j. Remove two cabinet top hold-down screws.
Refer to Figure 14.
k. Lift cabinet top to a vertical position by hinging
it on the rear hold-down brackets. Refer to
Figure 15.
NOTE: Cabinet top may be raised and hinged on
the rear hold-down brackets or supported against
wall behind dryer while servicing.
l. Carefully withdraw the wire harness through
hole in cabinet top and lift the top off the hold-
down brackets. Refer to Figure 15.
NOTE: The instruction plate located on the cabinet
top will need to be replaced when replacing the top.