TLW2157N_SVG
1
1.
Ground Wire Placement
Figure 43
Installing Extension Onto Coin Slide: Option 1
1.
Insert coins and partially extend coin slide.
2.
Insert coin slide on its side through meter case opening. Then
rotate 90 degrees to its proper orientation.
3.
Return coin slide and hook slide pins onto meter case.
4.
Continue coin slide installation according to manufacturer’s
instructions.
5.
Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.
Installing Extension Onto Coin Slide: Option Two
1.
Install coin slide according to manufacturer’s instructions.
2.
Insert coins into coin slide and slowly push slide in. Stop be-
fore coins fall into coin box. This will allow installing exten-
sion through meter case service door opening.
3.
Install slide extension onto top of coin slide using two screws.
Refer to
Figure 42
.
4.
Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.
Additional Dryer Security
Located on the service door of meter case models is a flat Phillips
head screw. During shipment, this screw is used to attach the
service door to the meter case. For additional security, this screw
can be reinstalled inside the control hood of your unit. Refer to
instructions below for installation.
1.
Remove the Phillips head screw from service door (refer to
Figure 44
).
2.
Remove two screws holding control panel to control hood.
3.
Tilt control panel forward and lay on a protective pad to pre-
vent scratching of cabinet top.
4.
Insert Phillips head screw down through double “D” hole in
left rear corner of cabinet top (inside control hood) until it en-
gages retainer nut located on left rear corner gusset of cabinet.
5.
Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten
screw. Torque of a power driver could over-tighten
screw causing damage to cabinet assembly.
D687I_SVG
1
1.
Double “D” Hole
Figure 44
Installation
Part No. 512680R10
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
41
Summary of Contents for D677I_SVG
Page 2: ......
