TLW1564K_SVG
4
3
2
1
1.
Lockwashers
2.
Attaching Screws
3.
Slide Extension
4.
Coin Slide
Figure 37
2.
Insert coins and partially extend coin slide.
3.
Insert coin slide on its side through meter case opening. Then
rotate 90 degrees to its proper orientation.
4.
Return coin slide and hook slide pins onto meter case.
5.
Continue coin slide installation according to manufacturer’s
instructions.
NOTE: During coin slide installation, make sure acti-
vation lever is up and off the switch. Refer to
Figure
38
.
TLW2090N_SVG
1
1.
Lever Off Switch
Figure 38
6.
Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.
Installing Extension Onto Coin Slide: Option Two
1.
Install coin slide according to manufacturer’s instructions.
2.
Insert coins into coin slide and slowly push slide in. Stop be-
fore coins fall into coin box. This will allow installing exten-
sion through meter case service door opening.
3.
Install slide extension onto top of coin slide using two screws
and lockwashers. Refer to
Figure 1
.
NOTE: Make sure extension lever is above switch
activation lever.
4.
Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.
Slide Extension Assembly – Models Starting Serial No.
1211
1.
Remove slide extension parts from parts accessories bag in-
cluded in unit.
2.
Install extension lever with arm that has one star facing down.
Refer to
Figure 39
.
Installation
Part No. 512680R10
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
39
Summary of Contents for D677I_SVG
Page 2: ......
