1.
To view the burner flame, remove the lower front panel of the
dryer.
2.
Close the loading door and start the dryer in a heat setting (re-
fer to the operation instructions). The dryer will start, the ig-
niter will glow red and the main burner will ignite.
IMPORTANT: If all air is not purged out of gas line,
gas igniter may go off before gas is ignited. If this
happens, after approximately two minutes igniter
will again attempt gas ignition.
IMPORTANT: If igniter does not light, make sure gas
is turned on.
3.
After the dryer has operated for approximately five minutes,
observe burner flame through lower front panel.
4.
Adjust the air shutter to obtain a soft, uniform blue flame. (A
lazy, yellow-tipped flame indicates lack of air. A harsh, roar-
ing, very blue flame indicates too much air.) Adjust the air
shutter as follows:
a. Loosen the air shutter lockscrew.
b. Turn the air shutter to the left to get a luminous yellow-
tipped flame, then turn it back slowly to the right to obtain
a steady, soft blue flame.
c. After the air shutter is adjusted for proper flame, tighten
the air shutter lockscrew securely.
5.
Reinstall the lower front panel.
WARNING
For personal safety, lower front panel must be in
place during normal operation.
W046
6.
After the dryer has operated for approximately three minutes,
exhaust air or exhaust pipe should be warm.
Coin Slide, MDC, and NetMaster Models Through Serial No.
0803 and Nonmetered Models
D700I_SVG
6
5
4
3
2
1
Coin Slide, MDC, and NetMaster Models Starting Serial No.
0804
DRY2235N_SVG
1.
Closed Position
2.
Shut-Off Valve Handle
3.
Air Shutter Lockscrew
4.
Air Shutter
5.
1/8 in. [3.1 mm] Pipe Plug (For checking manifold pres-
sure)
6.
Open Position
Figure 33
Vending
Meter Case
Metered Models
The factory mounted coin meter case does not include the service
door lock, coin slide (if applicable), coin drawer, coin drawer
lock or keys. These parts must be ordered (at extra cost) accord-
ing to the purchaser’s requirements direct from the manufacturer
of your choice.
Installation
32
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Part No. 512680R10
Summary of Contents for D677I_SVG
Page 2: ......
