Allen-Bradley 1404-M4, User Manual

Page: 44 / 356

Publication 1404-UM001D-EN-E - October 2004
3-18 Powermonitor 3000 Operations
3. Change the value of the parameter by pressing the Up Arrow
and Down Arrow keys until the desired parameter value is
displayed. Notice the phase indicators on the right-hand side
remain solid and the parameter being modified is still flashing.
4. After the desired parameter value is displayed, press the Enter
key to write the new value to the Master Module and set the
Display Module back to Program mode. Notice the phase
indicators on the right-hand side are now flashing and the
parameter being modified is now solid.
5. If you begin to edit the wrong parameter, press the Escape key.
This returns the original parameter value, does not modify the
Master Module, and returns the Display Module to Program
mode. Notice the phase indicators on the right-hand side are
flashing again, and the parameter being modified is now solid.
Setting a Default Screen
To set the current Display Module view as the default screen, press
the
Enter key. The display will read “Set Default” with “No” flashing in
the second line. Press the Down Arrow key to change “No” to “Yes.”
Press the Enter key again to confirm your selection.
The Display Module will now return to the screen you have selected
on power up or after 30 minutes of inactivity on the Display Module.
Issuing Commands
The Display Module allows you to issue commands to the
Powermonitor 3000. These commands include relay and KYZ output
forcing; clearing the Min/Max Log; clearing energy and amp-hour
counters, status input counters and setpoint counters, and restoring
the factory defaults.
To issue a command, you must enter Program Mode and enter the
correct unit Password .