HYDROGEN GENERATOR
H
2
Page 8
Install Method 2: Direct connect to your water supply
1. Install Angle Stop Adapter (included) to COLD WATER SUPPLY LINE. Locate the cold water line.
Shut off the cold water supply. Unscrew the flexible supply line from the angle stop. Attach the
adapter. (Fits standard 1/2” and 3/8” plumbing.)
2. ATTACH THE WHITE 1/4” TUBING TO THE ANGLE STOP ADAPTER
(Fig. 1) Attach the white 1/4” tubing to the adapter by simply pushing firmly into the white port.
Give a gentle tug to ensure proper connection. It should not come out. You will need a way to
route the white tubing from the adapter to your ionpia H2. Most newer sinks have cutouts that
will work for this. If not, drill a 1/4” hole.
3. ATTACH THE WHITE 1/4” TUBING TO YOUR ionpia H
2
. (Fig. 2) Attach opposite end (free end) of
the 1/4” tubing to the white Water Source Inlet port on the back of the ionpia H
2
. To attach the
white tubing, simply push it firmly into the Water Source Inlet port. Give it a gentle tug to ensure
proper connection. It should not come out. To remove tubing, press the collet towards the fitting
and pull the tubing out at the same time.
NOTE:
Use of faucet port is NOT recommended as it will NOT produce Hydrogen-rich water,
only filtered water.
4. POSITION YOUR ionpia H
2
- Ensure it is on a hard and level surface. See installation precautions.
5. CONNECT THE POWER CORD - Use an appropriate grounded outlet.
6. TURN THE COLD WATER SUPPLY ON. Open the valve on the Angle Stop Adapter. The valve is
open when the blue handle on the Angle Stop Adapter is parallel with the 1/4” white tubing.
Check all connections for leaks.
Fig. 1
Angle Stop Adaptor
Fig. 2
Tap Water Inlet Connection
https://vimeo.com/144697017
Watch video for how to direct plumb The ionpia H
2
1/4” tubing
going to
The ionpia H2
Cold Water
Shut Off Valve
Angel Stop
Valve
To Existing
Faucet
Connect 1/4” tubing coming from Angle
Stop Valve to
Water Source Inlet Port for
Hydrogen-rich Water.
Faucet Port -
Filtered Water Only.
No H2 Production
