HYDROGEN GENERATOR
H
2
Page 11
Replacing your filters
• DO NOT disconnect any of the fittings or plumbing inside of The ionpia H
2
.
This is not
necessary and will void your valuable warranty.
• Be sure to change the filters one at a time as they need to be installed in the correct
position.
4. Swing the filter outwards at a 90-degree angle and turn counter clockwise a quarter
turn to release. Then remove by pulling straight out of the filter saddle. See Figure 1.
5. Hold the new filter at a 90-degree angle and place into the filter saddle by aligning the
grooves. Press it in and turn clockwise a quarter turn to lock it into place. See Figure 2.
6. After installing your new filters, close the Filter Cover.
7. Turn on source water to the ionpia using either the diverter or the Cold Water Supply.
8. It is important to flush the filters before you start drinking the water. Do this by running
water through the unit for several minutes (or until clear) and discard the water.
Fig. 1
Removing Filter
Fig. 2
Installing Filter
