HYDROGEN GENERATOR
H
2
Page 9
Installing Digital Flow Meter
1. Slide open the battery case cover and put in 2 AAA batteries. Replace the cover.
2. Make sure the water is SHUT OFF. Decide where in your white ¼” tubing you would like to
place the DigiFlow Meter. Using a sharp knife or sharp pair of kitchen scissors, make a straight cut
through the tubing.
3. Push the inlet tubing into the quick connect fittings on each side. Push until they are fully
seated, then give a light pull to be sure that they are seated properly.
Operating the Digital Flow Meter
The DigiFlow 8800T will automatically turn on when water is flowing through and show remaining
filter life capacity. It will automatically shut off 10 seconds after the water flow stops. When no
water is being ran through it you can view the remaining filter life by pressing CHECK/RESET
button.
*The DigiFlow meter counts down, meaning it will show you how many gallons are left, not how
many have been used.
When the meter reaches zero(0), indicating your filters have expired, the DigiFlow meter will start
making a series of short beeping noises and blink zero(0) to notify you that it is time to replace
your filters. To reset the meter press and hold the CHECK/RESET button for 5 seconds until the
capacity is reset to 700 gallons. When the battery gets low the meter will beep as though the
filter is expired, however it will not show zero(0) and a picture of a battery will show in the corner
of the screen.
