HYDROGEN GENERATOR
H
2
Page 10
4
Operation
5
Replacing your filters
Replacing your filters in a timely manner as recommended by the manufacturer is very important
for optimum hydrogen production as well as producing the healthiest, contaminant-free water.
• DO NOT disconnect any of the fittings or plumbing inside of The ionpia H
2
.
This is not
necessary and will void your valuable warranty.
• Be sure to change the filters one at a time as they need to be installed in the correct
position.
The filters ARE NOT INTERCHANGEABLE.
1. Turn off source water either at your tap or at the Angle Stop Adapter.
2. Place a container under the water dispenser and turn flow control knob to the right to start
the flow of water and remove any residual water inside your ionpia H2.
3. Open Filter Cover.
Note: If your ionpia H2 is connected directly to your cold water
line, skip step 1 and start at step 2.
1. Turn your tap water onto cold, then turn the lever on your
diverter valve. This will divert the water from the tap to The ionpia
H
2
. At this point, check all connections for leaks,
tighten or re-seat if needed. If the diverter is leaking at the
faucet, use Teflon tape.
2. Place your glass under The ionpia H
2
water outlet and turn the
flow control knob to the right to start water flow.
3. It is important to flush the filters before you start drinking the
water, after initial installation or filter replacement.
Do this by running water through the unit for several
minutes (or just until it is clear) and discard the water.
* Some discoloration can be expected but may not always be
present when flushing the filters.
