Alienware Area-51 R3 Threadripper Edition, Service Manual

Page: 66 / 199

Replacing the drive-bay heat
sensor cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer . After working inside your
computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance .
Procedure
1 Route the drive-bay heat-sensor cable through the slot on the chassis.
2 Align the tab on the drive-bay heat-sensor cable on the chassis.
3 Push the release tab on the drive-bay heat-sensor cable and press it into
place.
4 Lay the chassis on the left side.
5 Connect the drive-bay heat-sensor cable to the system board. See “ system-
board components .
Post-requisites
1 Replace the left and right side-panels. See “ Replacing the side panels ”.
2 Replace the stability foot .
66