Removing the hard drive
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
Before working inside your computer
.
After working inside your computer, follow the instructions
in
After working inside your computer
. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
CAUTION: Hard drives are fragile. Exercise care when
handling the hard drive.
CAUTION: To avoid data loss, do not remove the hard drive
while the computer is in sleep or on state.
Prerequisites
Remove the
base panel
.
Procedure
NOTE: Your computer can accommodate either one 2.5-inch hard drive or
two solid-state drives.
1
Remove the screws that secure the hard-drive assembly to the computer
base.
2
Using the pull tab, disconnect the hard-drive cable from the system board.
27
Summary of Contents for 13 R2
