Alfa Laval MMPX 303SGP-11, Manual

Page: 98 / 181

ventas@fdm.com.pe
fdmsac@gmail.com
Movil:959440045
98
18. Fit frame hood (8). The two eye-bolts must be
fitted in the holes nearest to the electric
motor.
In case of Major Service remove the
connecting housing and fit a new O-ring on
the insert (2).
✔
Check point
‘‘5.4.1 Paring disc height adjustment” on page
63. To be performed at Major Service and if
the bowl spindle has been dismantled.
19. Fit inlet/outlet housings (3 and 4).
Tighten nut (2).
Left-hand thread!
Then rotate the bowl by means of the flat belt.
If the bowl does not rotate freely or a scraping
noise is heard, incorrect bowl assembly or
incorrect height adjustment of the paring disc
can be the cause.
20. Make sure that the gasket on the safety
device is in position. If not, glue with Loctite
407.
Fit and secure safety device (1).
21. Fit the connecting hoses if they have been
removed. Make sure to fit their gasket rings.
22. Fit the water tank on the frame bottom part if
it has been removed.
NOTE
To avoid damage on the inlet pipe the
tightening torque must not exceed 30 Nm.
G
0
0
729
41
1. Connecting housing
2. Insert
3. Height
adjusting ring(s)
G
0
07
35
31
G
0
07
36
21
www.fdm.com.pe