[email protected]
Movil:959440045
5.3 Check points at Intermediate Service
5 Service Instructions
56
5.3.5
Bowl hood and sliding bowl
bottom
Poor sealing between the bowl hood seal ring and
the edge of the sliding bowl bottom will cause a
leakage of process liquid from the bowl.
Fit a new bowl hood seal ring at each
Intermediate Service (IS) if the old ring is
damaged or indented more than 0,5 mm.
Fit a new ring as follows:
Press the ring into the groove with a straight
board (1” x 4”), placed across the ring.
NOTE
If a new ring is too narrow, put it into hot
water, 70 - 80 °C for about 5 minutes.
If it is too wide it will recover after drying at 80
- 90 °C for about 24 hours.
G
0
07
10
21
A
Sealing surface in the bowl between bowl hood
and sliding bowl bottom
G0
0
7
1
1
2
1
Exchange of seal ring in bowl hood
www.fdm.com.pe
Summary of Contents for MMPX 303SGP-11
