4.7 Assemble stands
Some models of plate heat exchangers are delivered without the stands assembled. Follow the
instruction below.
WARNING
Risk of crushing.
The equipment is heavy.
Be careful when handling the equipment. Do not reach in under equipment that is not secured.
WARNING
Risk of crushing.
Never work under hanging load.
Always make safety arrangement to avoid crushing.
1
On delivery, cover plates are attached on the
frame plate and support column in the same
positions where the stands shall be
assembled.
2
Lift up the equipment according to Section
3
Remove the screws, the washers, and the
nuts and then remove the cover plates.
4
Use the same screws, washers and nuts to
assemble the stands on the plate heat
exchanger according to the picture.
5
For Front 15 units two stabilising bars should
also be assembled according to the picture.
200000420-4-EN-GB
42
4 Installation
EN