Alfa Laval AFPX 617XGV-14/74CG, Instruction Manual

Page: 70 / 154

3.3 Intermediate Service (IS), check points 3 Dismantling/Assembly
70
1. Remove the old lining and place the new
lining blank in the wall pillar.
2. Fasten the mounting tool between the wall
pillars as shown in the illustration. Clamp the
wear lining with the tool.
3. Tighten the tool nut with a spanner until the
lining is firmly pressed to its seat.
4. Bend the shank (1) at right angles to the
outside of the bowl wall using a drift.
5. Back off the nut of the tool and remove it.
6. Remove the lining and cut the shank so that it
ends 0,5 - 1,5 mm (A) from the bowl wall.
7. Fit the wear lining in the wall pillar and clamp
it with the tool. Knock the shank flat against
the wall of the pillar.
S
003
20
1
1
G
0
29
86
1
1
G
0
298
71
1
G
0
29
89
21
G
0
2
989
41
S
0
031
81
1