12/35
ALFA IN a.s. ©
www.alfain.eu
Picture 8 - Adjusting the gas flow
F1
Gas Cylinder
F2
Cylidner Valve
F4
Pressure Reducer
F5
High Pressure Manometer
F6
Low Pressure Manometer
F7
Adjusting Screw
F8
Gas outlet
F9
Solenoid Valve
F10
Chain
ADJUSTING THE MACHINE FOR WELDING OF ALUMINIUM
1. Replace the rollers
G2
for rollers
G2
with U-profile of the groove (for AL
welding)
2. Loosen the nut
G5
on EURO connector
3. Replace the torch used on steel for aluminum torch or at least replace
the liner for Liner tefl.
G6
.
4. Replace the capillary from the EURO connector
G1
.
5. Cut end of the teflon liner
G6
so that it is near the rollers.
6. Thread the end of the teflon liner with sustainpipe for teflon and plastic
liner
G7
for stabilization.
7. Put the torch on the EURO connector
G1
and insert the wire.
Picture 9 – Customization of the feed for the aluminum wire