15/23
ALFA IN a.s. ©
www.alfain.eu
INSERTING THE WIRE TO THE TORCH AND CONNECTION OF GROUND
CABLE
Fig. 11 Connecting the ground cable and the torch (illustrative picture)
1. Connect the torch
B6
to connector
B8
on the machine while the machine
is turned off.
2. Connect the ground cable
B4
to the quick connector (-) of welding cables.
3. Connect the ground clamps
B5
to the weldment
B7
or to the welding table.
4.
Notice
When inserting the wire do not point with torch to the eyes!
5. Remove the gas nozzle from the torch.
6. Unscrew the current nozzle.
7. Connect the machine to power supply.
8. Turn the main switch
A9
on the rear panel to ON.
9. With
MENU
button and knob
A4
select the mode MIG/MAG.
10.
In submenu of welding parameters selection choose 2T or 4T.
11.
Press the torch button and the welding wire is fed into the torch. After
coming off from the torch tube, screw the current nozzle and gas nozzle
on.
12.
Before welding, spray the area in a gas hose and current nozzle with
a separation spray, to prevent damage.
