13/23
ALFA IN a.s. ©
www.alfain.eu
Inductance
0-10 (5)
-
-
Down slope
-
0-10 s (0 s)
Hot Start
-
-
0-10 (0)
Arc Force
-
-
0-10 (0)
SYSTEM SETTINGS
Rotate the knob
A4
and then press the knob
A6
for parameters settings.
The last position in submenu of system settings is
Factory reset
.
Press the knob
A6
for Factory reset performance.
Fig. 8 Submenu of system settings
7. GETTING STARTED MIG/MAG
Getting started must be consistent with technical data and conditions of use.
CHOOSING THE FEEDING ROLL
In all machines (ALFA IN MIG / MAG) rolls with two grooves are used. These
grooves are intended for two different wire diameters (e.g. 0,8 and 1,0 mm).
Rolls for wire feed must comply with the diameter and material of the welding
wire. Only this way a smooth wire feed can be achieved. Irregularities of the wire
feed leads to a poor quality of welding and deformation of the wire.
A
B
C
Fig. 9
The influence of the roll groove on the welding wire
A
Correct
B
Wrong
C
Wrong
