0
J. DISARMING WITHOUT A TRANSMITTER
OVErrIdE THE ALArM WITHOUT pASSWOrd pIN COdE:
(Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.
. Enter the vehicle and turn the ignition switch to ‘ON’ position. (Alarm will sound.)
. Within 0 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now start and operate the
vehicle normally.
OVErrIdE THE ALArM WITH pASSWOrd pIN COdE:
(Alarm Feature IV - Programming)
If the valet switch easily found, and defeated, this security system allows the consumer to
program a password pin code. Offering a higher level of security.
. Enter the vehicle and turn the ignition switch to ‘ON’ position. (Alarm will sound.)
. Within 5 seconds, enter your chosen first digit by pressing and releasing the Valet Switch.
. Within 5 seconds after the last entered press, turn the Ignition Switch “OFF” then “ON”.
4. Within 5 seconds, enter your chosen second by pressing and releasing the Valet Switch.
5. Turn the ignition switch “OFF” position.
[4] Chirps form siren/horn, [] flash from parking light and LED will turn off to indicate the system
was disarmed.
Note : You must override the alarm within 60 seconds. If not, the system will automatically
re-arm.
EXAMpLE: To Override The System With The password Code 83, you would;
. Enter the vehicle and turn the ignition switch to ‘ON’ position. (Alarm will sound.)
. Within 5 seconds, Press and Release the Valet Switch 8 times
. Within 5 seconds of the last entered 0ths digit, Press the Ignition Switch “Off” then “ON”.
4. Within 5 seconds, Press and Release the Valet Switch times
5. Turn the Ignition Switch to “Off” position.
[4] Chirps from siren/horn, [] flashes from parking light and LED will turn off to indicate the
system was disarmed.
K. VALET MODE: (System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all
alarm function is bypassed, however the remote panic feature and remote door locks will remain
operational. To use the valet mode, the system must first be disarmed either by using you remote
transmitter, or by operating the Manual override sequence.
Enter Valet Mode:
. From the disarmed condition, turn the ignition to “ON” position.
. Push and hold valet switch for seconds until the LED turns on. The
LED wills remain on as long as the system is in ‘valet mode’.
Exit Valet Mode:
. Return to normal operation, turn ignition ‘on’.
. Push and hold valet switch for seconds, The LED will turn off
indicating the system is exiting the valet mode.
rEMOTE VALET:
(System in Disarm or Valet mode)
Press and release
button on the transmitter three times within
seconds to enter / exit valet mode.
A parking flash to confirm enters valet mode and two parking lights
flashing to confirm exit valet mode.
L. CAR LOCATOR
Press the
✱
button to activate the car locator function. The siren
will chirp 6 times. The parking light will flash times, for you to easily
locate your car.
remote door Lock
remote door Unlock
