Alemite Carbon Shield, Installation, Operation And Maintenance Manual

Page: 29 / 58

www.alemitecarbonshield.com
ALEMITE CARbON SHIELD SERvICE SHEET | 27
using “change
Parameters” feature
1. The “Change Parameters” feature allows an end
user with the required password to change the
system setup parameters. For example the user
can change the CFM output by changing the mist
pressure, or change the oil or air temperature
set point. (Fig. 68)
2. The Carbon Shield controller allows the end
user to adapt the system to the installation
variables such as piping distance, and diameter,
number of fittings and piping bends, etc. by
selecting the “Change Parameters” button, the
user can access the screen below. (Fig. 69)
3. by selecting the “Air Flow” button, the user can
access the “Flow Parameters” screen. The user
can either adjust the mist pressure value so that
the air flow reading matches the sum of the CFM
of the fittings used in the installation
at 20 inches of water column, or adjust the mist
pressure to produce the mist flow rate that
is closest to the ideal flow rate for the points
needing lubrication. (Fig. 70)
4. The user can also select the “Oil Temperature”
button to adjust the oil temperature as needed.
Adjusting oil temperature also adjusts air
temperature to the same value. (Fig.71)
Fig. 68
Fig. 70
Fig. 71
Fig. 71
Fig. 69
NEW IMAGE TO COME