Alean AL-238P, Installation Manual

Page: 24 / 29

AL-238
PPROGRAMMING GUIDE
24
03 550003 Partition 3
password (6 #
N represents programming address
01~05, that is, 5 partitions;
04 550004 Partition 4
password
05 550005 Partition 5
password
Partition
remote
control 1 54 01 remote control 1 Assign the remote control to partition 1,
arm and disarm through the remote
control;
Input format: 54+01+X+#
N represents programming address
01~16, namely: remote control 1~16;
X means: 0=prohibit 1=allow;
The default factory setting is 0;
02 remote control 2
… … …
16 remote control 16
Partition
remote
control 2 55 01 remote control 1 Assign the remote control to partition 2,
arm and disarm through the remote
control;
Input format: 55+01+X+#
N represents programming address
01~16, namely: remote control 1~16;
X means: 0=prohibit 1=allow;
The default factory setting is 0;
02 remote control 2
… … …
16 remote control 16
Partition
remote
control 3 56 01 remote control 1 Assign the remote control to partition 3,
arm and disarm through the remote
control;
Input format: 56+01+X+#
N represents programming address
01~16, namely: remote control 1~16;
X means: 0=prohibit 1=allow;
The default factory setting is 0;
02 remote control 2
… … …
16 remote control 16
Partition
remote
control 4 57 01 remote control 1 Assign the remote control to partition 4,
arm and disarm through the remote
control;
Input format: 57+01+X+#
N represents programming address
01~16, namely: remote control 1~16;
X means: 0=prohibit 1=allow;
The default factory setting is 0;
02 remote control 2
… … …
16 remote control 16
Partition
remote
control 5 58 01 remote control 1 Assign the remote control to partition
5,arm and disarm through the remote
control;
Input format: 58+01+X+#
N represents programming address
01~16, namely: remote control 1~16;
X means: 0=prohibit 1=allow;
The default factory setting is 0;
02 remote control 2
… … …
16 remote control 16
4. Programming example
Prerequisite: When editing the parameters of the panel, please enter the programming mode first, then set the
parameters according to the programming table, and exit the programming after setting;
E.g. 1:
To modify installer password as: 654321, enter programming mode and input:
01+01+# the buzzer will beeps once after the modification..
E.g. 2:
To modify the arm/disarm permission to only arm for group 1 User Password.
Enter programming mode and input: 02+01+1+# buzzer will beeps once after
modification.
E.g. 3:
To modify zone 1arming /disarming time to: arm at 8:00am, disarm at 17:45. Enter
programming mode and input: 03+01+08001745 the buzzer will beeps once after
setting.