Getting Started
Page 5
Getting Started
What’s In The Box
Please make sure the following items were received in the box:
ShowTouch hardware
Power supply
Compact Flash card
This user guide
Ethernet crossover cable
Wall-mount hardware kit
Hardware Setup
Figure 2 Connections
1. Compact Flash
The Compact Flash card is shipped along with ShowTouch but is not installed during shipping in
order to protect the card socket. Install the Compact Flash card by removing the access cover on
the back panel and aligning the slots on the side of the card with the guides on the card socket.
The card should slide smoothly into place. If the card does not go into the socket or it is difficult
to install, check the alignment of the card. Replace the access cover.
2. Ethernet
ShowTouch must be connected via Ethernet to your show controller or show control network.
The Ethernet connector is located on the side of the panel. You may use either Ethernet connector
and then configure the connection settings from within the ShowTouch interface (see “Changing
the Network Settings”).
3. Power
Compact Flash
Ethernet
Power