Run and Edit Modes
Page 13
Run and Edit Modes
Before you begin using ShowTouch, it is important to understand the differences between Run and
Edit modes.
Run Mode
When an interface file is opened, the system immediately switches to Run mode. This means that
if the option to “Load File on Startup” is set, the Run mode will be entered immediately when
ShowTouch is powered on. It is also possible to enter Run mode manually using the “Run” button
on the Control Panel.
While in Run mode, the user can only interact with the currently loaded interface. It is not possible
to access popup menus or switch to secure pages without entering an unlock code. When in Run
mode, the system is essentially “Locked.”
In order for the user to interact with the interface, a connection to the show controller must be
established. If the show controller is unavailable when Run mode is entered, an error message will
be displayed and the interface unlock code will be requested. If the unlock code is not entered
within a reasonable amount of time, ShowTouch will try to connect to the show controller again.
This cycle will continue until the show controller can be reached or the unlock code is entered.
Exiting Run Mode
To exit Run mode, touch and hold in any empty location on the screen until the interface unlock
code is requested. Enter the interface unlock code to exit Run mode and display the Control Panel.
Figure 11 Enter Interface Unlock Code
