Alcatel 9400AWY, Installation Handbook

Page: 44 / 105

ED 01
3DB 05653 DAAA 43/104
2.4.3. Install the pole mounting on the mast.
2.4.3.1. Pole mounting assembly
This assembly is valid only for non-integrated antenna.
The outdoor “pole mounting“ system is designed for quick mechanical installation.
The mechanical system can be secured to any fixing pole with a diameter of between 90 and 114 mm.
A pole diameter of 114 mm is, however, recommended . With smaller diameters, mounting is possible, if
special attention is paid to the mechanical rigidity of the assembly.
There are also supports for fixing the pole to the wall: please consult us.
Various antenna types and sizes can be used, together with radio systems operating at different frequencies
and in a variety of configurations.
2.4.3.2. Installing the “pole mounting“
1
Figure 38 - Installation of the pole mounting for not integrated antenna
NB: Pole mounting can be installed on the Right or Left hand side of the pole.
- Position the Pole mounting support on the pole side as shown in the plant documentation.
- Position the U bolts (1) on the pole, fit the flat washers, “growe“ washers, nuts and lock nuts (2).
- Point the pole mounting in the required direction using a compass and a pair of binoculars, and then
secure the brackets.
-
To change the polarization : undo the three socket cap screws and turn the nose through 90 degrees
then tighten the screws again. See Figure 30 on page 35.