Alcatel-Lucent 7950 SR, System Management Manual

Page: 109 / 462

Security
7950 SR OS System Management Guide Page 109
write-version { 1 | 2 } — Select the hash version that will be used the next time the configuration file
is saved (or an info command is executed). Be careful to save the read and write version correctly, so
that the file can be properly processed after the next reboot or exec.
per-peer-queuing
Syntax [ no ] per-peer-queuing
Context config>system>security
Description
This command enables
CPM
hardware queuing per peer. This means that when a peering session is
established, the router will automatically allocate a separate
CPM
hardware queue for that peer.
The no form of the command disables
CPM
hardware queuing per peer.
Default
per-peer-queuing
source-address
Syntax source-address
Context config>system>security
Description
This command specifies the source address that should be used in all unsolicited packets sent by the
application.
This feature only applies on inband interfaces and does not apply on the outband management inter-
face. Packets going out the management interface will keep using that as source IP address. IN other
words, when the RADIUS server is reachable through both the management interface and a network
interface, the management interface is used despite whatever is configured under the source-address
statement.
When a source address is specified for the ptp application, the port-based 1588 hardware timestamp-
ing assist function will be applied to PTP packets matching the IPv4 address of the router interface
used to ingress the SR/ESS or IP address specified in this command. If the IP address is removed,
then the port-based 1588 hardware timestamping assist function will only be applied to PTP packets
matching the IPv4 address of the router interface.
application
Syntax application app [ ip-int-name|ip-address ]
no application app
Context config>system>security>source-address
Description
This command specifies the use of the source IP address specified by the source-address command.
Parameters
app — Specify the application name.