Alcatel-Lucent 7450 ESS Series, Configuration Manual

Page: 127 / 540

IP Router Configuration
7450 ESS OS Router Configuration Guide Page 127
cpu-protection
Syntax cpu-protection policy-id
no cpu-protection
Context config>router>interface
Description
This command assigns an existing CPU protection policy for the interface. The CPU protection
policies are configured in the
config>sys>security>cpu-protection>policy cpu-protection-policy-id
context.
Parameters
policy-id — Specifies an existing CPU protection policy.
Values
1 — 255
delayed-enable
Syntax delayed-enable seconds
no delayed-enable
Context config>router>if
Description
This command creates a delay to make the interface operational by the specified number of seconds
The value is used whenever the system attempts to bring the interface operationally up.
Parameters
seconds — Specifies a delay, in seconds, to make the interface operational.
Values
1 — 1200
local-proxy-arp
Syntax [ no ] local-proxy-arp
Context config>router>interface
Description
This command enables local proxy ARP on the interface.
Default
no local-proxy-arp
ldp-shortcut
Syntax [ no ] ldp-shortcut
Context config>router
Description
This command enables the resolution of IGP routes using LDP LSP across all network interfaces
participating in the IS-IS and OSPF routing protocol in the system.
When LDP shortcut is enabled, LDP populates the routing table with next-hop entries corresponding
to all prefixes for which it activated an LDP FEC. For a given prefix, two route entries are populated