Alcatel-Lucent 7450 ESS-1, Installation Manual

Page: 43 / 92

Installing the 7450 ESS-1
7450 ESS-1 Page 43
Table-Mounting the Chassis
The 7450 ESS-1 chassis can be installed on a flat surface, such as a tabletop or shelf. Rubber
footpads are included in with each accessory kit. It is optional to remove the factory installed rack
mounting brackets.
Before you begin, verify:
• The surface is sturdy and can support the weight of the router, or a stack of routers (up to
8 units high) and attached cables.
• Ventilation and maintenance requirements are met.
Figure 7 displays the locations to attach the footpads on the bottom side of the chassis.
Danger:
• Only trained and qualified personnel should install or replace this equipment.
Caution:
• There are no handles or hand grips on the 7450 ESS-1. Lift the router from underneath. Do
not lift the router by the MDA slots.
• The router should be installed on an elevated flat surface, off the floor.
• 7450 ESS-1 routers must not be stacked taller than 8 units high.
• The ventilation and maintenance clearance dimensions are the same for table-mounted units
as for rack-mounted units. See Chassis Clearance Requirements on page 30 .